Print This Page
Acrobat Reader
Flash Player
The simplest and most straight-forward pull test for wire crimps is LSI's Wire Crimp Test Gage. This crimp wheel fixture features 18 slots ranging from 0.031" to 0.437" and can accommodate up to #4 gage wire. Immediately test your wire crimp's integrity by inserting the crimped end of the wire into the appropriate slot of the wheel pull fixture, and lift up until either the crimp slips free (bad) or the weight is lifted free (good). A small dowel pin in the large slot is available for testing ring-type wire terminals.
The upper crimp fixture itself weighs 1.5 lb, and comes with the following detachable weights: 0.5 lb, 1 lb, 2 lb, 2 lb, and 5 lb. The maximum configurable weight is 12 lb. See the chart below for some common tensile strength standards.
- Zero maintenance
- Simple to use - "Good" if crimp holds, "Bad" if it slips
- Configurable - simply attach weights to bottom to desired net weight
- Accommodates wire from 22 AWG to 30 AWG
from 1/32" to 7/16"
(Click for larger view)
(Click for larger view)
| Minimum Tensile Strengths | |||||
|---|---|---|---|---|---|
| Wire Gage | SAE AS7928 Table II |
UL 486A Terminals |
UL 486C Splices |
DIN 41611/3 |
NASA-STD 8739.4 |
| 32 | 1.4 lb | ||||
| 30 | 2.1 lb | ||||
| 28 | 3.2 lb | 5 lb | |||
| 26 | 7 lb | 3 lb | 3 lb | 5.0 lb | 8 lb |
| 24 | 10 lb | 5 lb | 5 lb | 8.1 lb | 8 lb |
| 22 | 15 lb | 8 lb | 8 lb | 11.1 lb | 13 lb |
| 20 | 19 lb | 13 lb | 10 lb | 17.1 lb | 21 lb |
| 18 | 38 lb | 20 lb | 10 lb | 25.2 lb | 32 lb |
| 16 | 50 lb | 30 lb | 15 lb | 39.8 lb | 41 lb |
| 14 | 70 lb | 50 lb | 25 lb | 58.0 lb | 65 lb |
| 12 | 110 lb | 70 lb | 35 lb | 92.1 lb | 103 lb |
| Chart for reference only. Consult actual standard before testing. Highlighted values are those testable by the Wire Crimp Test Gage. For higher capacity wire crimp testing, see our FDHT. |
|||||
| Ordering Information | ||
|---|---|---|
| Part Number | Description | Price |
| Tester | ||
| 025-0000-0551-00 | Wire Crimp Test Gage | Quote |
